20 gauge [0.032 in. (0.81 mm)] copper covered steel center conductor; gas expanded polyethylene dielectric; inner shield aluminum-polypropylene laminated tape with overlap bonded to dielectric; outer shield of 34 AWG bare aluminum braid wire; jacket of black polyvinylchloride or polyethylene (flooded). Nominal O.D. 0.240 in. (6.10 mm).

Our RG 540 coaxial cable was developed to meet the increasing demands of tomorrow's broadband networks. It has the highest reability and flexibility of any coaxial cable, low RF attenuation. All this cables offer tough polyethylene jackets and a standardized, environmentally sealed connector interface engineered for reliability and craft friendliness. RG 540 is optimized for use in broadband feeder plants. RG 540 offers lower attenuation than larger traditional products, with unmatched flexibility, reliability and cost effectiveness.

HFC Network

HFC Network

Cat.3 Cable Cat.5 Cable Cat.5e Cable Cat.6 Cable

PHILIPS Push-Pull and Power Doubler module High gain, high output level and low non-linear Plug-in fixed or variable attenuator and equalizer(0~20dB). Plug-in fixed or variable inter-stage attenuator and equalizer(0~20dB). Two outputs with plug-in splitter or 1-tap Different frequency split is specified by clients Local and remote powering available Weatherproof and RF-screened die-cast housing

House amplifier TA200

Indoor and Outdoor wiring For patchcord production In cable trays As a backbone in Local Area Network On fences or walls Outdoor in flooded ducts

Low insertion loss High return loss and isolation Dual flush mounting tabs for easy installation Zinc housing that is plated for corrosion resistance Available in 2-way,3-way,4-way,6-way & 8-way splitter

Low insertion loss High return loss and isolation Zinc housing that is plated for corrosion resistance Available in 2-way,3-way,4-way,6-way & 8-way splitter

Low insertion loss High return loss and isolation Aluminum housing that is plated for corrosion resistance

Low insertion loss High return loss and isolation Aluminum housing that is plated for corrosion resistance

Adopt high-power transformer, no operating noises and low leak of magnetism, high power supply Anti-thunder and capacity of resist disturbing Automatic power pass, short circuit protection, Optical warning and resume ability Input 110V double assurance

Installed 8dB Forward Equalizer Return path attenuation possible for improved system performance via a plug-in attenuator 750 MHz and 870 MHz Models Available Backward Compatible With All Motor ola SSP Passives and Existing FFE Equalizers 12 A power passing Accepts Standard Motorola Accessories

Low insertion loss High return loss Easy and convenient installation

High quality 12 ports one tray 30 degree installation of adaptors, preventing eyes. From laser's hurt Easy to operate and convenient maintenance The tray suitable for FC, SC adapters

F59, F6 cable stripper, F6/F11 crimp, compression tool, and key for burglarproof lock

Hexangular press connecting tool, suitable for RG59,RG6,RG11 (0.475+0.324)

For RJ45 installation and stripping CAT5,CAT5e Cable

Punch Tool & Insertion Tool

Test CATV signal level both at channel and frequency mode At SCAN mode, it can scan all channels and store signal level information At spectrum mode, it can carry out spectrum display and test for a certain frequency range It can measure CATV TILT (can be set 2 channels) C/N ration A/V ration Trunk cable Vo1tage LCD clear1y displays all testing results User friendly menu with many useful functions

Test CATV signal level both at channel and frequency mode At SCAN mode, it can scan all channels and store signal level information At spectrum mode, it can carry out spectrum display and test for a certain frequency range It can measure CATV TILT (can be set 2 channels) C/N ration A/V ration Trunk cable Vo1tage LCD clear1y displays all testing results It can display two channels at the same time User friendly menu with many useful functions

Variable　attenuator 1~20dB, vertical installation, 0-1000MHz Low insertion loss High return loss

High quality metal housing 2 pcs inlet/outlet 24 cores total capacity Slide-in-lock design, over 90' opening angle tray Operating Temperature: -40~+65 C

plastic box easy to install with all accessories included up to 3 trays each can accommodate 8-18 sleeves 48 ports for pachcords size: 320*145*50mm

Spllitter & Tap plug 204dB/110dB, response:+/-0.5dB, return loss:16dB(0-1000MHz) High precision loss High return loss Small size, suitable for amplifier, optical node etc